The module with the calibration function, Calibration
method : Without electricity, Hold down the left key Plugged into a
power supply ,Display start flashing, loosen the left , Display voltage
of 5 v, sometimes according to 4.99 The
output voltage is measured with a multimeter , If the measured voltage
is higher than 5 v , need press the left button to 5V , if the voltage
more than 5v ,need press the right button to 5V ,then power off .This module use STN LCD ,will display voltage and current at the same time ,it's can press the button adjustable the volatge , single-press adjust 0.04V , long press 1S can quickly adjust the volatge ,input
voltage : 4.75-23V (Top 23 v, should be used within 20 v) Input voltage
must be higher than the output voltage of 1.5 v above, please make sure
the input voltage is negative access again, pick up the possible damage
to the module componentsOutput voltage: 0-15V Continuous adjustable, saved the set voltage automatically 3A peak current, should be used in 2A. Accuracy is 1%, the smallest according to 0.01, the unit is A, Under 10 ma will not display. High conversion efficiency, up to 96% (efficiency and the input and output voltage, current and pressure difference)Load regulation S (I) 0.8% or less, the voltage regulation S (u) 0.8% or lessRozměry: 50 x 30 x 10 mm
Upozornění: na zničení měničů vlivem překročených hodnot nebo nedostatečného chlazení se záruka nevztahuje!
MP2307DN buck step down
Tento produkt byl přidán dne Úterý 16. únor 2016.
